Siemens SINUMERIK 840D Operator's Manual page 9

0
03.04
Principle
Supplementary devices
Personnel
Procedure
Servicing
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Your SIEMENS 840D, 810D is designed using state-of-the-art
technology in conformity with recognized safety regulations,
standards and specifications.
The applications of SIEMENS controls can be expanded by adding
special additional devices, equipment and expansions supplied by
SIEMENS.
Only properly trained, authorized, reliable personnel must be
allowed to use this equipment. No-one without the necessary training
must be allowed to operate the control, even temporarily.
The areas of responsibility assigned to personnel involved in setting
up, operating and maintaining the equipment must be clearly
specified and their compliance verified.
Before the control is started up, personnel responsible for its
operation must have read and understood the Operator's Guides. The
company using this equipment is also obliged to carry out
continuous monitoring of the overall technical condition of the
equipment (with a view to identifying externally visible defects and
damage as well as changes in the operating behavior of the control).
Repairs to equipment may only be carried out by personnel specially
trained and qualified for the application in question in accordance
with the provisions specified in the maintenance and servicing guides.
All relevant safety regulations must be followed.
The following are deemed as improper usage and exclude the
manufacturer from all liability:
Any usage or application incompatible with or beyond the scope of
the items specified above.
Cases where the control is operated in a technically imperfect
condition, without due provision for safety considerations and/or
hazards, or in contravention with any of the instructions in the relevant
documentation.
Cases where faults which could affect safety are not remedied before
starting up the control.
0
Preface
Intended use
ix