Display Of Tool Data - Siemens SINUMERIK 810M Operating And Programming Manual
Hide thumbs
Also See for SINUMERIK 810M:
- Commissioning manual (736 pages) ,
- User manual (300 pages) ,
- Equipment manual (28 pages)
Table of Contents
Advertisement
3 Operating Sequences
3.1.4 Tool offset
Enter the geometry data in this screen form. Note that the location number in the magazine
table (e. g. 3) is the same as the D No. of the tool offset memory (e. g. D3).
Press the "GEOMETRY DATA"softkey to return to the "TOOL OFFSET " menu. You can
return to the standard menu by pressing the "RECALL" key twice.
If you are entering tool data from paper tape, observe
the instructions of the machine manufacturer.
3.1.4.6 Display of tool data
TOOL
OFFSET
GEOM.
DATA
or
D...
3-14
Press either "TOOL OFFSET" softkey or the
"GEOMETRY DATA" softkey.
Press the appropriate keys to page through the display
and select a certain D No. input is then displayed.
or
Select a D No. and press the search key. The tool
data under the D No. input is then displayed.
© Siemens AG 1990 All Rights Reserved
09.91
6ZB5 410-0EQ02
SINUMERIK 810M, GA3 (BN)
Advertisement
Table of Contents
