Operating Areas - Siemens SINUMERIK 840D Operator's Manual

1
Introduction

1.3 Operating areas

1.3 Operating areas
1-22
The basic functions are grouped in the following operating areas in
the control (in gray boxes):
Operating areas
Execution
of parts programs,
manual control
Editing data
for programs/
tool management
Development
and adaptation
of part programs
Reading in/out
programs and data
Alarm displays,
service displays
Adaptation of CNC
data to machine,
system settings
Only for
cycles option
Operating sequence
When you press the "Area switchover" key, operating areas are
displayed on the horizontal softkey bar and operating modes are
displayed on the vertical softkey bar. You can use this key to go to the
area menu bar from any location in the menu hierarchy if you wish to
select another operating mode or a different operating area.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
MACHINE
PARAMETERS
PROGRAM
SERVICES
DIAGNOSIS
START-UP
CYCLES
 Siemens AG, 2004. All rights reserved
1
03.04