Siemens SINUMERIK 840D Operator's Manual page 31

2
03.04
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
CTRL
Use the following key combinations to navigate in the process plan
and in the G code editor:
Ctrl + Pos1: Jump to the start.
Ctrl + End: Jump to the end.
Ctrl + C: Copy a selected area to the same global memory.
If nothing is selected, the content of the entire field is
saved in the buffer.
Ctrl + X: Copy a selected area to the same global memory and
cut.
CTRL +V: Insert the contents from the global memory to the cursor
position.
ALT
Blank, empty character
BACKSPACE
•
Delete the value in the input field from the right.
•
Delete the character after the cursor in insertion mode.
DEL
•
Delete the value in the parameter field
•
Delete the character marked by the cursor in insertion mode.
INSERT
•
Switch to tables and input fields in the editing mode (in this case
the input field is located in the insert mode) or
•
UNDO function on the table element and input fields (when
leaving a field with the edit key, the value is not accepted, but
rather reset to the previous value = UNDO).
•
Activate pocket calculator mode
TAB
Tab key
Operator Components/Operating Sequences
2.1 Operator panels
2
2-31