Siemens SINUMERIK 840D Operator's Manual page 8

0
Preface
Intended use
Warning Information
viii
Ordering data option
In this documentation you will find the symbol shown on the left with a
reference to an ordering data option. The function described will only
be executable if the control contains the designated option.
The following warning notices with varying degrees of significance are
used in the document:
Danger
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury or in substantial property damage.
Warning
Indicates a potentially hazardous situation which, if not avoided,
could result in death or serious injury or in substantial property
damage.
Caution
Used with the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in minor or moderate injury
or in property damage.
Caution
Used without safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
Notice
Used without the safety alert symbol indicates a potential situation
which, if not avoided, may result in an undesirable result or state.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
0
03.04
 Siemens AG, 2004. All rights reserved