Siemens SINUMERIK 840D Operator's Manual page 122

5
Parameters Operating Area
5.1 Tool data
Required offset values of a
facing wheel with
monitoring parameters
Assignment of
Tool-specific
Parameters
5-122
STC_TPG1
Entries in
tool parameters STC_TPG2
STC_DP1 403 STC_TPG3
STC_DP3 Length 1
STC_TPG4
STC_DP4 STC_TPG5
Length 2
STC_TPG6
STC_DP6 Radius
STC_TPG7
STC_TPG8
Wear values according
to requirement STC_TPG9
Other values must
e.g.
be set to zero
G18: Z/X plane
Effect
X
Length 1 in Y
G17:
Length 2 in X
Radius in X/Y
Length 1 in X
G18:
Length 2 in Z
Radius in Z/X
Length 1 in Z
G19:
Length 2 in Y
Radius in Y/Z
Parameters Meaning
Tool-specific parameters
$TC_TPG1 Spindle number
$TC_TPG2 Chaining rule
$TC_TPG3 Minimum wheel radius
$TC_TPG4 Minimum wheel width
$TC_TPG5 Current wheel width
$TC_TPG6 Maximum speed
$TC_TPG7 Maximum surface speed
$TC_TPG8 Angle of inclined wheel
$TC_TPG9 Param. no. for radius calc.
Additional parameters
$TC_TPC1 Angle of inclined wheel
up to
$TC_TPC10
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Spindle number
Chaining rule
Minimum wheel radius
Minimum wheel width
Current wheel width
Maximum speed
Max. surface speed
Angle of the inclined wheel
Parameter no. for radius calculation
F: Toolholder reference point
F
Z
Radius
Length 2 (Z)
 Siemens AG, 2004. All rights reserved
5
03.04
Data Type
Integer
Integer
Real
Real
Real
Real
Real
Real
Integer
Real
Real