Program Editing - Siemens SINUMERIK 840D Operator's Manual

4
Machine Operating Area
4.6 Automatic mode

4.6.3 Program editing

Correct
program
Cycle Start
4-106
Function
As soon as a syntax error in the part program is detected by the
control, program processing is interrupted and the syntax error is
displayed in the alarm line.
You can make small changes in the stop or reset state.
Operating sequence
"AUTO" mode is selected in the "Machine" operating area.
It is not possible to pass over the point of interruption. The feedrate
correction switch is active.
The program status is in the "Stop" or "Reset" state.
The correction editor is displayed with this softkey. If an error occurs,
the faulty block is highlighted and can be corrected. The cursor is
positioned on the error.
Once you have corrected the block with an error, you can continue the
program with the "Cycle Start" key.
•
Stop state:
Only program lines that have not yet been executed can be
edited.
•
Reset status:
All program lines can be edited.
•
Program Running state:
Program cannot be edited!
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
4
03.04
 Siemens AG, 2004. All rights reserved