Standard Pc Keyboard Mf-Ii - Siemens SINUMERIK 840D Operator's Manual

2
Operator Components/Operating Sequences
2.3 Machine control panel keys
Reset
References

2.3.7 Standard PC keyboard MF-II

2-42
Reset
• Execution of the current program is aborted.
• Messages from the cycle monitoring are deleted (except for
POWER ON, Cycle Start and "Acknowledge alarm" alarms).
• The channel is shifted to "reset" state, i.e.,
− The NC control remains synchronized with the machine.
− The control is in its initial state and ready for a new program
run.
(See also)
/FB1/K1: Description of Functions Mode Group, Channel, Program
Operation
A standard PC keyboard can be connected. However, a machine
control panel is required in addition to this keyboard.
The special function keys on the operator panel front can also be
used with the standard PC keyboard. The following table shows the
keys on which the horizontal and vertical softkeys are mapped:
Standard
F1 F2 F3
PC
Keyboard
vertic vertic vertic
with
Soft. Soft. Soft.
SHIFT
1 2 3
horiz horiz horiz
without
Soft. Soft. Soft.
SHIFT
1 2 3
Standard
PC Home
Esc
Insert
keyboard
with
SHIFT
without
SHIFT
switched
off
Num Block
Caution
The standard PC keyboard does not meet the requirements (EMC) of
a SINUMERIK control. For this reason, it should only be used for
installation and servicing purposes.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
F4 F5 F6 F7 F8
vertic
vertic vertic vertic vertic
Soft. Soft. Soft. Soft. Soft.
4 5 6 7 8
horiz horiz horiz horiz
horiz
Soft. Soft. Soft. Soft.
Soft.
4 5 6 8
7
Page Page
Enter
Tab
Up Down
 Siemens AG, 2004. All rights reserved
2
03.04
F9 F10 F11 F12
CUSTOM
Num Block
5 1 3 7
9
P R O G R AM
O F F S E T
M A N A G ER