Execution From External Source Via Rs-232 Interface; Reading Iso Programs In/Out Via Rs-232 C - Siemens SINUMERIK 840D Operator's Manual

7
03.04
Error
log
7.5.7

Execution from external source via RS-232 interface

Execution
from ext.
Start

7.5.8 Reading ISO programs in/out via RS-232 C

 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Operating sequence
You can display information about the data transfer operation by
pressing softkey "Error log".
Function
You can download external programs via the RS-232 interface to the
NC and edit them immediately. The buffer size for the part program
blocks temporarily stored in the NC depends on the NC memory and
its distribution.
•
H=... contains, as well as
•
an error acknowledgment.
Operating sequence
All downloadable data/programs are displayed.
Select a range, e.g. part program and
Press softkey "Execution from ext.".
Execution commences after "Start".
Function
ISO programs can be read in and out in punched tape format.
Further information
FANUC 0 control system programs can be read in and out as ISO
programs.
The punched tape format for ISO programs (ISO punched tape
format) is not the same as Siemens HMI Embedded punched tape
format.
Services Operating Area
7.5 Main services screen
7
7-269