Siemens SINUMERIK 840D Operator's Manual page 89

4
03.04
Feed
mm/min
Tools
Zoom
act. val.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Nibbling
The spindle window is replaced by a nibble window if the "Nibbling"
technology option is set.
The active function, if any, appears at the top left in the window
header:
•
PON Punching ON
•
SON Nibbling ON
•
SPOF Punching/nibbling OFF
The following values are displayed:
•
"Section" and "Number of strokes" are displayed inverted, if you
have programmed "Length of section" or "Number of sections" at
the automatic block partition.
•
The "Time delay" is only displayed if you have set "Punching
with time delay".
Feedrate window
Display of the setpoint and actual value of the feedrate as well as the
position of the feedrate override switch
setpoint to be traversed is dependent on the override switch.
When G00 (rapid traverse movement) is programmed, the rapid
override value is displayed.
Tool window
Display of active tool offset (e.g. D1), tool currently in use (T no.), pre-
selected tool (on milling machines) plus currently active travel
commands (e.g. G01, SPLINE, ...), or
tool radius compensation not active (e.g. G40).
Increases the size of the actual-value display.
Machine Operating Area
4.4 Jog operating mode
(in %). The actual
4
4-89