Copy File And Insert - Siemens SINUMERIK 840D Operator's Manual

6
Program Operating Area
6.7 Manage programs

6.7.9 Copy file and insert

Copy
Insert OK
6-240
Further information
• The system checks whether a program may be executed when the
program is called (after selection via operator input or from part
program). If you want it to be enabled, you must enable it
beforehand.
Function
This subsection explains how files can be copied.
Operating sequence
Position the cursor on the file that you want to copy and press the
softkey "Copy".
The file is marked as the source for copying.
Press the softkey "Insert", enter a new name and confirm with "OK".
When you insert a file in a workpiece directory, you can change its file
type with the "Select" key. The file types are automatically adjusted in
the global part program and the global subroutine directory.
Further information
•
Only files can be stored in a workpiece directory, not other
workpiece directories.
•
If the target specified is incorrect an error message is output.
•
If a workpiece directory is copied, all the files that it contains are
copied at the same time.
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
6
03.04
 Siemens AG, 2004. All rights reserved