Siemens SINUMERIK 840D Operator's Manual page 286

8
Diagnosis Operating Area
8.3 Service display
SPL
Saving
Displayed signals
SPL power up status: Bit0:
8-286
Diagnosis Chan1 Jog
Channel reset
Program aborted
Safty Integrated SPL
Variable Bits
$A_INSE(P) 01...08
$A_OUTSE(P) 09...16
$A_INSI(P) 17...24
$A_OUTSI(P)
25...32
Signal
Cross-checking fill level
Cross-checking status
Cross-checking control word
SPL power up status
SPL powered up
Service Service Service SI
System
axis drive
resources
In the "Variable" selection box, you can select:
$A_INSE(P) corresponds to simultaneous activation of
$A_INSE upper line, origin of the NCK and
$A_INSEP lower line, origin of the PLC
and effectively the same for the other variables:
$A_OUTSE(P)
$A_INSI(P)
$A_OUTSI (P)
$A_MARKERSI(P)
Under Bit you can request an 8-bit range from the selected signal.
The variables that have been selected and the associated bit areas
are saved and are taken into account when subsequently selecting
the screen.
In addition to the current values, the origin of the displayed NCK/PLC
signals is displayed.
The settings are reset the next time the control is powered up.
Cross-checking fill level
Cross-checking status
Cross-checking control word
SPL power up status
SPL powered up
SPL interface parameters set
Bit1: SPL program file SAFE.SPL loaded
Bit2: NCK waiting for PLC power-up
Bit3: PLC power-up complete
Bit4: Interrupt needs to be assigned for SPL start
Bit5: Interrupt has been assigned for SPL start
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
MPF.DIR
SP25.MPF
X1
Area Value
0000 0000 0000 0000
NCK
PLC 0000 0000 0000 0000
0000 0000 0000 0000
NCK
0000 0000 0000 0000
PLC
0000 0000 0000 0000
NCK
0000 0000 0000 0000
PLC
0000 0000 0000 0000
NCK
PLC 0000 0000 0000 0000
Value
0
No errores occured
IS
0000 0000 0000 0000
No
Comm. Action
log log
(CDC Crosswise data comparison)
 Siemens AG, 2004. All rights reserved
8
03.04
Status SI
SGF/SGA
SPL
Version