Displaying System Frames - Siemens SINUMERIK 840D Operator's Manual

4
Machine Operating Area
4.4 Jog operating mode
References

4.4.7 Displaying system frames

4-96
The "Swivel Adjust" softkey is used to declare the swiveled plane as
the new "zero" plane for the active swivel data record
(TOOLCARRIER).
In this case, when you select "Swivel", positioning is at this swiveled
plane with rotation through
X=0
Y=0
Z=0
The following messages are output for checking purposes:
"Swivel: Adjustment terminated"
"Swivel: Adjustment not possible"
/PGZ/ Programming Guide Cycles, Chapter 3 "Swiveling"
If system frames are activated via MD, they can be displayed via the
Parameter operating area, Work offsets.
The following assignment is applicable:
$P_SETFR System frame for actual value setting, scratching
$P_EXTFR System frame for work offset external
$P_PARTFR System frame for TCARR and PAROT
$P_TOOLFR System frame for TOROT and TOFRAME
$P_WPFR System frame for workpiece reference points
$P_CYCFR System frame for cycles
Both the offset set via frames (coarse and fine) and the rotation and
mirroring defined there are displayed. Display is according to the
position in the frame chain.
The following figure shows an example screen layout:
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
4
03.04
 Siemens AG, 2004. All rights reserved