Interface Parameterization - Siemens SINUMERIK 840D Operator's Manual

7
03.04
7.4.1

Interface parameterization

Parameters for serial
printer
Parameters for archiving
with PG/PC
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
7.4 RS-232 C interface parameters
Default: RS-232-C printer
A printer with a serial interface is connected with a suitable cable
(cable check to CTS).
Interface COM 1
Device type RTS-CTS
Baud rate 9600
Stop bits 1
Parity None
Data bits 8
XON 11 (H)
XOFF 13 (H)
Transmission 0C (FormFeed)
end
Default: RS-232-C PG/PC
Interface COM 1
Device type RTS-CTS
Baud rate 9600
Stop bits 1
Parity None
Data bits 8
XON 11 (H)
XOFF 13 (H)
Transmission 1A
end
This setting allows files in SINUMERIK 840D PC format to be
archived and imported.
"Stop with end of transmission character" must not be selected for
transmission of MSD and FDD files.
Other settings are possible with ASCII data. They must match the
settings on the programming device. Cable 6FX 2002-1AA01- is used
for this purpose.
Services Operating Area
Selection of interface:
COM 1 or COM 2
Start with XON
Program start with LF
X Block end with CR LF
X Stop with end of transmission
end character
Evaluate DSR signal
Leader and trailer
X Punch tape format
Cycle watchdog
Selection of interface:
COM 1 or COM 2
Start with XON
Program start with LF
Block end with CR LF
Stop with end of transmission
end character
X Evaluate DSR signal
Leader and trailer
Punch tape format
X Cycle watchdog
7
7-257