Select Tool List; Create New Tool - Siemens SINUMERIK 840D Operator's Manual

5
03.04
Tool parameters
Magazine parameters

5.4.2 Select tool list

Tool list

5.4.3 Create new tool

 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
5.4 ShopMill tool management
– Magazine location/magazine number
– Tool type
– Tool name
– Duplo number
– Geometry length 1
– Geometry radius
– Wear length 1
– Wear radius
– Type of tool monitoring:
– Tool status: Tool disabled
– Tool status: Tool oversized (right and left half locations)
– Tool status: Tool in fixed location
– Fillet radius
– Angle for conical milling tools
– Magazine location disabled
Operating sequence
If "ShopMill" tool management is set up, the tool list menu is
automatically displayed when you call up the "Parameters" operating
area. Otherwise you can call the tool list via softkey.
Function
You create new tools in the tool list. A selection of tool types is
displayed for this purpose. The tool type determines which geometry
data are required and how they will be computed. The following
common tool types are available:
Parameters Operating Area
Tool life
Number of workpieces
5
5-153