Display And Modify Tool Data - Siemens SINUMERIK 840D Operator's Manual

5
03.04

5.3.3 Display and modify tool data

Magazine Tool list
list
or
Tool details
D No.
+
D No.
-
New
edge
Abort
OK
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/810D Operator's Guide HMI Embedded (BEM) – 03.04 Edition
Position the cursor bar on the appropriate tool.
The tool is now selected for editing.
Function
You can view and edit the tool data of the tool selected in the
"Magazine list" or "Tool list".
You can edit the following tool edge data:
•
offset values
•
Monitoring data
Operating sequence
"Magazine list" or "Tool list".
Position the cursor bar on the appropriate tool.
The appropriate tool is selected.
Select the "Tool details" softkey.
The "Tool data" menu is displayed.
The vertical softkey bar changes again.
Display/edit tool data:
You can display and edit tool data in menus:
•
"Magazine list" (if the tool data, edge data and tool user data are
configured in the magazine list)
Switches forward by one edge.
Switches back by one edge.
Creates new edge.
Edit compensation data of new edge.
Abort input.
Confirm and accept input.
Parameters Operating Area
5.3 Tool management
5
5-145