Figure 20: Connecting An Srx240 Services Gateway To The Cli - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
86

Figure 20: Connecting an SRX240 Services Gateway to the CLI

NOTE: Figure 20 on page 86
device. A remote connection to the services gateway through a modem
requires the cable and connector shown (provided in the services gateway
accessory box), plus a DB-9 male to DB-25 male (or similar) adapter for your
modem, which you must purchase separately.
To connect to the CLI using a local management device through the console port on the
services gateway:
Turn off power to the services gateway.
1.
Turn off power to the management device, such as a PC or laptop computer, that you
2.
are using to access the CLI.
Plug one end of the CAT-5e (Ethernet cable) supplied with your services gateway
3.
into the RJ-45 to DB-9 serial port adapter supplied with your services gateway.
Plug the RJ-45 to DB-9 serial port adapter into the serial port on the management
4.
device.
Connect the other end of the Ethernet cable to the console port on the services
5.
gateway.
Turn on the power to the management device.
6.
Start your asynchronous terminal emulation application (such as Microsoft Windows
7.
HyperTerminal) and select the appropriate
Configure the port settings shown in
8.
shows a connection to a local management
port to use (for example,
COM
Table 37 on page 87.
Copyright © 2015, Juniper Networks, Inc.
).
COM1