Connecting To The Srx240 Services Gateway Setup Wizard - Juniper SRX240 Hardware Manual

Related
Documentation

Connecting to the SRX240 Services Gateway Setup Wizard

Copyright © 2015, Juniper Networks, Inc.
If the device is operating in a Common Criteria environment, see the
for Junos OS Public Sector Certifications
Connecting to the SRX240 Services Gateway Setup Wizard on page 83
Connecting the SRX240 Services Gateway to the CLI on page 85
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 94
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
Setup Wizard
SRX240 Services Gateway Secure Web Access Overview on page 84
If you plan to use the setup wizard to configure the services gateway, you must connect
through one of the built-in Gigabit Ethernet ports. You can use any built-in Ethernet port
except port 0/0.
To enable communication between the management device and the services gateway,
ports 0/1 through 0/15 are preconfigured with the IP address
assign an IP address on the
To connect to the Ethernet port:
Ensure that the IP address for the Ethernet port on the management device is
1.
configured in one of the following ways:
The IP address is assigned by DHCP.
The IP address is on the
Turn off the management device.
2.
Plug one end of the CAT-5e (Ethernet cable) into the Ethernet port on the management
3.
device.
Connect the other end of the Ethernet cable to the built-in Gigabit Ethernet port (any
4.
one port between 0/1 and 0/15) on the services gateway as shown in
Figure 19 on page 84.
Chapter 15: Performing Initial Configuration
.
network to any connected device.
192.168.1.0/24
192.168.1.0/24 subnetwork (but is not
Configuration Guides
. DHCP is used to
192.168.1.1
192.168.1.1 ).
83