Using The Cli - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
Related
Documentation
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI
94
}
}
}
}
vlans {
vlan-trust {
vlan-id 3;
l3-interface vlan.0;
}
}
protocols {
stp;
}
SRX240 Services Gateway Software Configuration Overview on page 79
SRX240 Services Gateway Autoinstallation Overview on page 49
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 94
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface on page 97
This procedure connects the services gateway to the network but does not enable it to
forward traffic. For complete information about enabling the services gateway to forward
traffic, including examples, see the appropriate Junos OS configuration guides.
To configure the software:
Verify that the services gateway is powered on.
1.
Log in as the root user. There is no password.
2.
Start the CLI:
3.
root# cli
root@>
Enter configuration mode:
4.
configure
[edit]
root@#
Set the root authentication password by entering a cleartext password, an encrypted
5.
password, or an SSH public key string (DSA or RSA):
[edit]
root@# set system root-authentication plain-text-password
New password: password
Retype new password: password
Copyright © 2015, Juniper Networks, Inc.