Copper Conductors Warning - Juniper SRX240 Hardware Manual

SRX240 Services Gateway Hardware Guide
Related
Documentation
160
Install the services gateway in compliance with the following local, national, or
international electrical codes:
United States—National Fire Protection Association (NFPA 70), United States
National Electrical Code
Canada—Canadian Electrical Code, Part 1, CSA C22.1
Other countries—International Electromechanical Commission (IEC) 60364, Part 1
through Part 7
Evaluated to the TN power system
Locate the emergency power-off switch for the room in which you are working so that
if an electrical accident occurs, you can quickly turn off the power.
Do not work alone if potentially hazardous conditions exist anywhere in your workspace.
Never assume that power is disconnected from a circuit. Always check the circuit before
starting to work.
Carefully look for possible hazards in your work area, such as moist floors, ungrounded
power extension cords, and missing safety grounds.
Operate the services gateway within marked electrical ratings and product usage
instructions.
For the services gateway and peripheral equipment to function safely and correctly,
use the cables and connectors specified for the attached peripheral equipment, and
make certain they are in good condition.

Copper Conductors Warning

WARNING: Use copper conductors only.
Waarschuwing Gebruik alleen koperen geleiders.
Varoitus Käytä vain kuparijohtimia.
Attention Utilisez uniquement des conducteurs en cuivre.
Warnung Verwenden Sie ausschließlich Kupferleiter.
Avvertenza Usate unicamente dei conduttori di rame.
Advarsel Bruk bare kobberledninger.
Aviso Utilize apenas fios condutores de cobre.
¡Atención! Emplee sólo conductores de cobre.
Varning! Använd endast ledare av koppar.
SRX240 Services Gateway Definition of Safety Warning Levels on page 133
Copyright © 2015, Juniper Networks, Inc.