Juniper SRX240 Hardware Manual page 68

SRX240 Services Gateway Hardware Guide
Related
Documentation
50
the network. You can use either the J-Web interface or the CLI to configure a device for
autoinstallation.
For the autoinstallation process to work, you must store one or more host-specific or
default configuration files on a configuration server in the network and have a service
available—typically Dynamic Host Configuration Protocol (DHCP)—to assign an IP address
to the services gateway.
Autoinstallation takes place automatically when you connect an Ethernet port on a new
services gateway to the network and power on the device. To simplify the process, you
can explicitly enable autoinstallation on a device and specify a configuration server, an
autoinstallation interface, and a protocol for IP address acquisition.
For more information about configuring autoinstallation, see the following topics:
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
Connecting the SRX240 Services Gateway to the AC Power Source on page 69
Grounding the SRX240 Services Gateway on page 60
Powering On and Powering Off the SRX240 Services Gateway on page 74
Copyright © 2015, Juniper Networks, Inc.