Performing Initial Configuration; Srx240 Services Gateway Software Configuration Overview; Preparing The Srx240 Services Gateway For Configuration - Juniper SRX240 Hardware Manual

CHAPTER 15

Performing Initial Configuration

SRX240 Services Gateway Software Configuration Overview

Preparing the SRX240 Services Gateway for Configuration

Copyright © 2015, Juniper Networks, Inc.
SRX240 Services Gateway Software Configuration Overview on page 79
Connecting to the SRX240 Services Gateway Setup Wizard on page 83
SRX240 Services Gateway Secure Web Access Overview on page 84
Connecting the SRX240 Services Gateway to the CLI on page 85
Viewing Factory Default Settings of the SRX240 Services Gateway on page 87
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 94
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface on page 97
Configuring PoE Functionality on the SRX240 Services Gateway on page 101
This topic includes the following sections:
Preparing the SRX240 Services Gateway for Configuration on page 79
Understanding the Factory Default Configuration on page 80
Understanding Built-In Ethernet Ports and Initial Configuration on page 80
Mapping the Chassis Cluster Ports on page 81
Understanding Management Access on page 82
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled. When the services gateway is powered on, it is ready to be configured.
You can perform the initial configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the services gateway, gather the configuration information required
to deploy the services gateway in your network. At minimum, the setup wizard requires
the following information:
Device name to be used on the network
79