Monitoring The Srx240 Services Gateway Using Chassis Alarm Conditions; Table 42: Srx240 Services Gateway Chassis Alarm Conditions And Corrective - Juniper SRX240 Hardware Manual

Monitoring the SRX240 Services Gateway Using Chassis Alarm Conditions

Copyright © 2015, Juniper Networks, Inc.
When the services gateway detects an alarm condition, the Alarm LED on the front panel
turns red or yellow as appropriate.
To view a more detailed description of the cause of the alarm, issue the
alarms CLI command.
For more information about the
Initial Configuration for Security Devices
Monitoring and Troubleshooting for Security Devices
Table 42 on page 113 describes the chassis alarm conditions and corrective actions.
Table 42: SRX240 Services Gateway Chassis Alarm Conditions and
Corrective Actions
Component Alarm Condition
Boot media The services
gateway boots from
an alternate boot
device.
Mini-Physical A Mini-PIM has
Interface failed.
Module
(Mini-PIM)
Chapter 17: Troubleshooting Components
command, see the following guides:
show chassis alarms
Action
If the internal flash memory fails at startup,
the services gateway automatically boots
itself from the alternative boot device
(USB storage device).
NOTE: If you configured your services
gateway to boot from an alternative boot
device, ignore this alarm condition.
Reformat the internal flash memory and
install a bootable image. (See the
Configuration for Security Devices
If you did not configure the services
gateway to boot from an alternative boot
device, contact Juniper Networks Technical
Assistance Center (JTAC). See
Networks Technical Assistance Center" on
page 118.
Contact JTAC. See "Juniper Networks
Technical Assistance Center" on page
If you must replace the failed Mini-PIM, see
SRX Series Services Gateways for
the
the Branch Physical Interface Modules
Hardware Guide
for information about
replacing the Mini-PIMs.
show chassis
Alarm
Severity
Yellow
(minor)
Initial
.)
"Juniper
Red
118. (major)
113