Separately Installed Options - Omron I537-E2-01 User Manual

‹

Separately Installed Options

The separately installed options include Scaling Meters and Analog Operators.
„
Scaling Meters
A Scaling Meter is attached to a multi-function analog output from the Inverter and is used to display rota-
tional speeds of motors, line speeds, etc., in physical units.
Models and Application
The standard models of Scaling Meters are listed in the following table.
Model No.
K3TJ-V111R
K3TJ-V111G
K3TJ-V116R
K3TJ-V116G
Note The power supply circuit is isolated from the input circuits.
Standard Specifications
The standard specifications of the Scaling Meters are listed below.
Sampling Period
Display Refresh Cycle
Measurement Averaging Methods
Number of Samples for Averaging 1, 2, 4, or 8 samples
Max. No. of Display Digits
Display
Decimal Point Display
Scaling Method
Scaling Range
Zero Limit Range
Overrange Values
Zero Suppression
External Controls
Protective Structure (conforming
to IEC standards)
Memory Protection
* IP51 requires that the optional K32-L49SC Drop-proof Cover is used. The protective structure is IP50 without it.
-10
9
Control Power Supply
100 to 200 VAC
24 VDC, isolated
(See note.)
V V
K3TJ-V11
2 times/s
2 times/s
Simple average or moving average
4 digits (-1999 to 9999)
7-segment LEDs, character height: 14.2 mm
User-set using function selection switch and up/down keys.
Shifting and scaling are user-set using function selection switch and up/down
keys.
-1999 to 9999
0 to 99 digits
Flashing display
Supported
Present value hold (by short-circuiting terminal on front panel)
Front panel display: IP51
Case: IP20
Terminal section: IP00
Non-volatile memory
Display
Red LED
Green LED
Red LED
Green LED
Specifications
*