Omron I537-E2-01 User Manual page 81

„
Digital Operator Displays during Autotuning
The following displays will appear on the Digital Operator during autotuning.
Digital Operator Display
Motor rated : T1-02
Autotuning started: TUn10
Autotuning
Autotuning completed
Table 4.3 Digital Operator Displays during Autotuning
Stop command input
Trial Operation Procedures
Description
The autotuning start display will appear when all set-
tings through T1-04 have been completed. The
A.TUNE and DRIVE indicators will be lit.
Autotuning will start when the RUN Key is pressed
from the autotuning start display.
If the STOP Key is pressed or a measurement error
occurs during autotuning and error message will be
display and autotuning will be stopped.
Refer to Errors during Autotuning on page 7-10.
END will be displayed after approximately 1 to 2 min-
utes, indicating that autotuning has been completed.
9
4-