Voice Processor Setup: Setup - Korg PA1X User Manual

242 Global edit mode

Voice Processor Setup: Setup

Max Volume
Use this parameter to set the maximum volume of the MP3
Player.
Audio Out
This (non-editable) parameter shows the fixed output for the
MP3 Player (Left+Right).
CD Audio
This section only appears when the optional CDRW-1 CD drive
has been installed.
Max Volume
Use this parameter to set the maximum volume of the Audio CD
Player.
Audio Out
This (non-editable) parameter shows the fixed output for the
Audio CD (Left+Right).
Voice Processor Setup: Setup
In this page you can select a Voice Processor Setup, and set some
general parameters for the current Setup.
Setup
Voice Processor Setup
Use this parameter to select a Voice Processor Setup.
Setup parameters are global and do not change when a different
preset is recalled. Setup parameters are all the parameters found
in the Voice Processor Setup edit section, including Lead input
level and pan, Compression/Gate, and EQ parameters among
many others.
They are parameters that would typically be set for a given situa-
tion based on the singer, microphone or studio configuration
and then left that way as a basis for the presets within the Voice
Processor. If you change your microphone (or singer!) the EQ/
Compression settings need to only be adjusted once in the setup
section.
If you wish to save your setup settings, just select the "Write Glo-
bal-Voice Processor Setup" command from the page menu (see
page 257).
Harmony Settings
Gbl
These parameters are general settings for the Harmony section
voices, that are saved on the Voice Processor Setup.
Gbl
Vibrato Mode
This parameter sets whether the vibrato follows the onset and
attack of the model (Boost) or is instantaneous (Manual). The
joystick controls the vibrato in both modes.
Boost The preset value for each voice (see "Vibrato
Amount" on page 250) is boosted when moving
the joystick.
Manual Vibrato starts from a value of 0, and is fully con-
trolled by the joystick.
Gbl
Vibrato Rx Enable
This parameter lets you turn vibrato reception on or off.
Gbl
Octave Transpose
This transposes the harmony voices in Notes mode (see "Har-
mony Mode" on page 248). The value corresponds to octaves.
This is useful when used in conjunction with "In Note Range-
High" and "In Note Range-Low" parameters (see page 237).
When receiving notes from MIDI, this value is summed to the
value of the "Octave Transpose In" parameter, found in the
"MIDI: MIDI In Control" page (see page 237).
Pitch Bend Range
Only available in Notes mode. Sets in semitones the range that
MIDI pitch bend information will alter the pitch of the harmo-
nies in Notes mode.
Damper Mode
Use this parameter to define the effect of the Damper pedal on
the Voice Processor. The Damper message can be received from
the Damper pedal connected to the DAMPER jack, or from the
MIDI IN (CC#64).
Off Damper disabled.
Sustain Notes sent to the Voice Processor are sustained as
long as the pedal is kept pressed. Therefore,
chords sent to the Harmony section do not
change until the pedal is released or a different
chord is recognized.
Harmony Hold
Harmony voices are sustained while you continue
to sing through them. On activation (press and
hold the Damper pedal), you can freeze whatever
the harmony voices are doing, and they will hold
their notes (in a very natural way) until you let
go.
Note: The Harmony Hold function can also be
assigned to an Assignable Footswitch or Switch.
VPs
VPs
VPs
VPs
VPs