Installing Additional Ram - Korg PA1X User Manual

Installing additional RAM

Pa1X comes equipped with 16MB of RAM already installed, which can be used for storing samples and Song editing. You can install an
additional 16MB of RAM in the form of a single 72-pin SIMM module (for a list of tested SIMMs, see www.korgpa.com). Please contact
your Korg dealer for more information.
1. Before you begin, turn the instrument off, and disconnect the power cable.
2. Turn the instrument upside down, and remove the screws (a), to
open the cover (A) and gain access to the option compartment.
Note: Block any possible access to the inside of the instrument dur-
ing installation to prevent any items from falling inside. In the
event something does fall into the instrument, please immediately
contact your nearest Service Center.
3. As you face the option compartment opening, locate the two
RAM slots. A 16MB SIMM module is already present in one of
the slots.
4. Lightly push out on the two securing clamps (one on each end).
Installing additional RAM
Pa1X Pro
A
a
a
a
a
Pa1X
a
a
A
a
a
399
a
a
a
a
a
a
a