Korg PA1X User Manual page 270

266 Disk edit mode
Save
Saving all data of a specified type
In addition to the above, you can save all data of a specified type
by selecting the corresponding folder.
1. If saving to a floppy disk, insert the disk into the disk drive.
2. The full content ("All") of the internal memory is already
shown. Select it, and press Open to open it. A list of User
data types appear (each type is a separate folder).
3. Select the folder containing the type of data you wish to
save, and press Save To to confirm the selection. The list of
files of the target device is shown.
4. If needed, select a different target device, by using the
Device pop-up menu. When the target device is selected, its
content will appear in the display.
5. At this point, you can:
• Press the New SET button and create a new ".SET" folder
(see "Creating a new ".SET" folder" on page 268), or
• Select an existing ".SET" folder.
6. Press Save to confirm.
Warning: After confirming, all data of the selected type in
the target folder is deleted.
Saving a single bank
You can save a single User bank with a single operation. A bank
corresponds to a button on the control panel of the instrument
(i.e. a button of the STYLE section).
1. If saving to a floppy disk, insert the disk into the disk drive.
2. The full content ("All") of the internal memory is already
shown. Select it, and press Open to open it. A list of User
data types appear (each type is a separate folder).
3. Select the folder containing the type of data you wish to
save, and press Open to open it. The list of contained banks
is shown.
4. Select the bank to be saved, and press Save To to confirm
the selection. The list of files of the target device is shown.
5. If needed, select a different target device, by using the
Device pop-up menu. When the target device is selected, its
content will appear in the display.
6. At this point, you can:
• Press the New SET button and create a new ".SET" folder
(see "Creating a new ".SET" folder" on page 268), or
• Select an existing ".SET" folder.