Korg PA1X User Manual page 341

011: Exciter/Enhancer
This effect is a combination of the Exciter, which adds a punch
to the sound and the Enhancer, which adds spread and presence.
Stereo In - Stereo Out
Left
LEQ HEQ
Exciter
EQ Trim
EQ Trim
Exciter
Right
D -mod
Exciter Blend
Sets the intensity (depth) of the Exciter effect
Src
a
Selects the modulation source of the Exciter intensity
Amt
Sets the modulation amount of the Exciter intensity
Emphatic Point
Sets the frequency to be emphasized
Src
b
Selects the modulation source of the frequency to be emphasized
Amt
Sets the amount of modulation of the frequency to be emphasized
Enhancer Dly L (Enhancer Delay L) [msec]
c
Sets the delay time for the Enhancer left channel
Enhancer Dly R (Enhancer Delay R) [msec]
d
Sets the delay time for the Enhancer right channel
Enhancer Depth
Sets the determines to what degree the Enhancer effect is applied
e Src
Selects the modulation source of the Enhancer width
Amt
Sets the modulation amount of the Enhancer width
EQ Trim
f
Sets the 2-band EQ input level
Pre LEQ Gain [dB]
Table , "Sets the gain of Low EQ," on page 330
g
Pre HEQ Gain [dB]
Table , "Sets the gain of High EQ," on page 330
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
h
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
a: Exciter Blend
This parameter sets the depth (intensity) of the Exciter effect.
Positive values give a frequency pattern (to be emphasized) dif-
ferent from negative values.
b: Emphatic Point
This parameter sets the frequency to be emphasized. Higher val-
ues will emphasize lower frequencies.
c: Enhancer Dly L [msec], d: Enhancer Dly R [msec]
These parameters set the delay time for the Enhancer left and
right channel. Specifying a slightly different delay time for the
left and right channel will add a stereo image, depth, and width
to the sound.
Wet / Dry
Delay
Depth
Delay
Enhancer
Wet / Dry
–100...+100
☞
,
Off...Tempo
–100...+100
0...70
☞
,
Off...Tempo
–70...+70
0.0...50.0msec
☞
0.0...50.0msec
☞
0...100
Off...Tempo
–100...+100
0...100
–15.0...+15.0dB
–15.0...+15.0dB
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
012: Sub Oscillator
This effect adds very low frequencies to the input signal. It is
very useful when simulating a roaring drum sound or emphasiz-
ing powerful low range. This effect is different from the equalizer
in that you can add very low range harmonics. You can also
adjust the oscillator frequency to match a particular note num-
ber, for use as an octaver.
Stereo In - Stereo Out
Left
Envelope Shape
Envelope Sens
Pre LPF
D -mod
Fixed Frequency
Note Interval, Fine
Note No.
Note (Key Follow)
Envelope Sens Pre LPF
Envelope Shape
Right
OSC Mode
a Determines whether the oscillator frequency follows the note number or
whether it is fixed
Note Interval
Sets the pitch difference from the note number when OSC Mode=Note (Key
Follow)
b
Note Fine
Fine adjustment of the oscillator frequency
Fixed Frequency [Hz]
Sets the oscillator frequency when OSC Mode=Fixed
Src
c Selects the modulation source for the oscillator frequency when OSC
Mode=Fixed
Amt
Sets the oscillator frequency modulation amount when OSC Mode=Fixed
Envelope Pre LPF
d Sets the upper limit of the frequency range for which very low harmonics are
added
Envelope Sens (Envelope Sensitivity)
Sets the sensitivity with which very low harmonics are added
e
Envelope Shape
Sets the oscillator's volume envelope curve
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
f
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
a: OSC Mode, b: Note Interval, b: Note Fine
The "OSC Mode" parameter selects the oscillator operation
mode. When Note (Key Follow) is selected, the oscillator's fre-
quency is determined based on the note number, allowing you to
use it as an octaver. The "Note Interval" parameter sets the pitch
offset from the original note number by semitone steps. The
"Note Fine" parameter allows you to fine-tune in steps of cents.
d: Envelope Pre LPF
This parameter sets the upper limit of the frequency range to
which very low harmonics are added. Adjust this parameter if you
do not want to add lower harmonics to the higher range.
Effects 337
Filter/Dynamic
Wet / Dry
Sine Oscillator
Fixed
Pitch
OSC Mode
Wet / Dry
Note (Key Follow), Fixed
☞
–48...0
☞
–100...+100
10.0...80.0Hz
Off...Tempo
–80...+80Hz
1...100
☞
0...100
–100...+100
Dry, 1:99...99:1, Wet
Off...Tempo
–100...+100
☞