Korg PA1X User Manual page 347

Feedback
Sets the feedback amount
i
High Damp [%]
Sets the feedback damping amount in the high range
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
j
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
022: Envelope Flanger
This Flanger uses an envelope generator for modulation. You
will obtain the same pattern of flanging each time you play. You
can also control the Flanger directly using the modulation
source.
Stereo In - Stereo Out
Left
Flanger
Flanger
Right
D-mod
D -mod
EG Attack/Decay Sweep Mode
EG
L Dly Bottom [msec] (L Delay Bottom)0.0...50.0msec
Sets the lower limit of the delay time on the left channel
a
L Dly Top [msec] (L Delay Top)0.0...50.0msec
Sets the upper limit of the delay time on the left channel
R Dly Bottom [msec] (R Delay Bottom)0.0...50.0msec
Sets the lower limit of the delay time on the right channel
b
R Dly Top [msec] (R Delay Top)0.0...50.0msec
Sets the upper limit of the delay time on the right channel
Sweep ModeEG, D-mod
Determines whether the flanger is controlled by the envelope gen-
erator or by the modulation source
c
SrcOff...Tempo
Selects the modulation source that triggers the EG (when EG is
selected for Sweep Mode), or modulation source that causes the
flanger to sweep (when D-mod is selected for Sweep Mode)
EG Attack
Sets the EG attack speed
d
EG Decay
Sets the EG decay speed
Feedback
e
Sets the feedback amount
High Damp [%]0...100%
f
Sets the feedback damping amount in the high range
Wet/Dry–Wet...–1:99, Dry, 1:99...Wet
Table , "Sets the balance between the effect and dry sounds," on
page 330
☞
010, 020,
SrcOff...Tempo
g
Table , "Selects the modulation source of the effect balance," on
page 330
Amt
Table , "Sets the modulation amount of the
effect balance," on page 330
c: Sweep Mode, c: Src
This parameter switches the flanger control mode. With "Sweep
Mode" = EG, the flanger will sweep using the envelope genera-
tor. This envelope generator is included in the envelope flanger,
and not related to the Pitch EG, Filter EG, or Amp EG.
The "Src" parameter selects the source that starts the envelope
generator. If you select, for example, Gate, the envelope genera-
tor will start when the note-on message is received.
–100...+100
☞
Fx:020
0...100%
☞
Fx:020
–Wet...–1:99, Dry, 1:99...Wet
☞
Fx:010, 020,
Off...Tempo
–100...+100
Wet / Dry
Feedback
High Damp
Wet / Dry
☞
Fx:009
☞
Fx:009
☞
Fx:009
☞
Fx:009
☞
,
☞
1...100
☞
1...100
☞
–100...+100
☞
Fx:020
☞
Fx:020
–100...+100
When "Sweep Mode" = D-mod, the modulation source can con-
trol the flanger directly. Select the modulation source using the
"Src" parameter.
The effect is off when a value for the modulation source speci-
fied for the "Src" parameter is smaller than 64, and the effect is
on when the value is 64 or higher. The Envelope Generator is
triggered when the value changes from 63 or smaller to 64 or
higher.
d: EG Attack, d: EG Decay
Attack and Decay speed are the only adjustable parameters on
this EG.
023: Phaser
This effect creates a swell by shifting the phase. It is very effective
on electric piano sounds. You can add spread to the sound by
offsetting the phase of the left and right LFOs from each other.
Stereo In - Stereo Out
Left
Right
LFO Shape
LFO: Tri / Sine
LFO Waveform
Selects LFO Waveform
a
LFO Shape
Determines how much the LFO waveform is changed
LFO Phase [degree]
b
Sets the LFO phase difference between the left and right
LFO Frequency [Hz]
Sets the LFO speed
Src
c
Selects the modulation source of LFO speed
Amt
Sets the modulation amount of LFO speed
BPM/MIDI Sync
Switches between using the frequency of the LFO speed and using the
tempo and notes
BPM
Selects MIDI Clock and assigns tempo
d
Base Note
Selects the type of notes that specify the LFO speed
Times
Sets the number of notes that specify the LFO speed
Manual
e
Sets the frequency to which the effect is applied
Depth
Sets the depth of LFO modulation
Src
f
Selects the modulation source for the LFO modulation depth
Amt
Sets the modulation amount of the LFO modulation depth
Resonance
Sets the resonance amount
g
High Damp [%]
Sets the resonance damping amount in the high range
Wet/Dry
Table , "Sets the balance between the effect and dry sounds," on page 330
Src
h
Table , "Selects the modulation source of the effect balance," on page 330
Amt
Table , "Sets the modulation amount of the effect bal-
ance," on page 330
Effects 343
Pitch/Phase Mod.
Wet / Dry
Phaser
Resonance
High Damp
Phaser
Wet / Dry
LFO Phase
Triangle, Sine
–100...+100
☞
Fx:020
–180...+180
☞
Fx:010
0.02...20.00Hz
☞
Fx:009,
Off...Tempo
–20.00...+20.00Hz
Off, On
☞
Fx:009,
MIDI, 40...240
☞
Fx:009
☞
Fx:009
x1...x16
☞
Fx:009
0...100
0...100
Off...Tempo
–100...+100
–100...+100
0...100%
☞
–Wet...–1:99, Dry, 1:99...Wet
☞
Fx:010,
Off...Tempo
–100...+100
☞