Alcatel-Lucent 7705 Interface Configuration Manual page 99

section-trace
Syntax section-trace {increment-z0
Context config>port>sonet-sdh
Description This command configures the section trace bytes in the SONET section header to interoperate with
some older versions of ADMs or regenerators that require an incremental STM ID. You can explicitly
configure an incremental STM value rather than a static one in the SDH overhead by specifying an
increment-z0 value.
Default byte
Parameters
increment-z0 —
byte value —
string string — specifies a text string that identifies the section
speed
Syntax speed {oc3}
no speed
Context config>port>sonet-sdh
Description
This command configures the speed of a SONET/SDH port. To change the port speed, the port must
be administratively shut down and all channels must be removed. When the port speed is changed, the
default channel configuration is recreated.
For Release 2.0, this option is available, but may not be configured, since only one speed type is
supported.
The no form of this command reverts back to the default value.
Default
oc3
Parameters oc3 — sets the speed of the port to OC3
7705 SAR OS Interface Configuration Guide
0x1
configures an incremental STM ID instead of a static value
sets values in SONET header bytes
Values
0 to 255 or 0x00 to 0xFF
Default
0x1
Values
a string up to 16 bytes
byte value string string}
| |
7705 SAR Interfaces
Page 99