Alcatel-Lucent 7705 Interface Configuration Manual page 103

Parameters mtu — sets the maximum allowable size of the MTU, expressed as an integer
report-alarm
Syntax [no] report-alarm
Context config>port>sonet-sdh>path
Description This command enables logging of SONET/SDH path alarms for a SONET/SDH port.
The no form of this command disables logging of the specified alarms.
Parameters pais — reports path alarm indication signal errors. When configured, path alarm indication signal
plop — reports path loss of pointer errors, per tributary. When configured, path loss of pointer traps
prdi — reports path remote defect indication errors. When configured, path remote defect indication
pplm — reports a path payload mismatch, which places the channel operationally down. When
prei — reports a path error condition raised by the remote end as a result of b3 errors received from
puneq — reports path unequipped errors
scramble
Syntax [no] scramble
Context config>port>sonet-sdh>path
Description This command enables SONET/SDH payload scrambling.
Scrambling randomizes the pattern of 1s and 0s carried in a SONET frame. Scrambling, or
rearranging, the pattern prevents continuous strings of all 1s or all 0s and meets the needs of physical
layer protocols that rely on sufficient transitions between 1s and 0s to maintain clocking.
7705 SAR OS Interface Configuration Guide
Values 512 to 1524 (in bytes)
pais plop
[ ] [
alarms are raised and cleared.
Default path alarm indication signal alarms are not issued
are raised but not cleared.
Default
path loss of pointer traps are issued
alarms are raised and cleared.
Default path remote defect indication alarms are not issued
configured, path payload mismatch traps are raised but not cleared.
Default path payload mismatch traps are issued
this node. When configured, path error traps are raised but not cleared.
Default path error traps are not issued
Default path unequipped traps are issued
prdi pplm prei puneq
] [ ] [ ] [ ] [
7705 SAR Interfaces
]
Page 103