Alcatel-Lucent 7705 Interface Configuration Manual page 155

7705 SAR OS Interface Configuration Guide
Table 15: Show Specific Port Output Fields (Ethernet Port) (Continued)
Label
Configured
Address
Hardware Address
Cfg Alarm
Alarm Status
Oper Speed
Config Speed
Oper Duplex
Config Duplex
MTU
Hold time up
Hold time down
Encap Type
Egr. Pool % Rate
MDI/MDX
Ingress Rate
Traffic Statistics
Octets
Input/Output
Description
The base chassis Ethernet MAC address
The interface's hardware or system assigned MAC address at its
protocol sub-layer
The type of alarms to be logged and reported for the Ethernet port
The current alarm state
The operating speed of the interface
The configured speed of the interface
Full — the link is operating at full duplex mode
Half — the link is operating at half duplex mode
Full — the link is set at full duplex mode
Half — the link is set at half duplex mode
The size of the largest packet that can be sent/received on the Ethernet
physical interface, specified in octets
The link-up dampening time in seconds
The link-down dampening time in seconds
Null — ingress frames will not use any tags or labels to delineate a
service
dot1q — ingress frames carry 802.1Q tags where each tag signifies a
different service
The amount of egress buffer space, expressed as a percentage of the
available buffer space, that will be allocated to the port or channel for
egress buffering
Ethernet type
The maximum amount of ingress bandwidth (in kilobits per second)
that this Ethernet interface can generate
The total number of octets received and transmitted on the port
7705 SAR Interfaces
Page 155