Alcatel-Lucent 7705 Interface Configuration Manual page 175

7705 SAR OS Interface Configuration Guide
Table 19: Show Port Channel Group Output Fields (Continued)
Label
Oper Status
Last State Change
Chan Grp IfIndex
Configured Mode
Encap Type
Admin MTU
Oper MTU
Scramble
Physical Link
Bundle Number
Idle Cycle Flags
Payload Fill Type
Payload Pattern
Signal Fill Type
Signal Pattern
Traffic stats
Description
Down — the port is administratively down
Up — the port is operationally up
Down — the port is operationally down
The last time the operational status of the port changed state
The channel group index number
network — the port is configured for transport network use
access — the port is configured for service access
The encapsulation type for the channel group (atm, cem, ipcp, or
ppp-auto)
The configured MTU
The negotiated size of the largest packet that can be sent on the
port or channel specified in octets
Indicates if payload scrambling is enabled on channel groups
(only applicable if encap type is atm)
Yes — a physical link is present
No — a physical link is not present
The number assigned to the multilink bundle
The value transmitted by the DS0, DS1, or E1 interface during
idle cycles
The payload type to be transmitted when the circuit emulation
service is not operational or temporarily experiences underrun
conditions (only valid for CESoPSN services)
Indicates the user-defined pattern transmitted if the payload fill
type is pattern
The signaling type to be transmitted when the circuit emulation
service is not operational or temporarily experiences underrun
conditions (only valid for CESoPSN with CAS)
Indicates the user-defined pattern transmitted if the payload fill
type is pattern
Octets input/output — the total number of octets
received and transmitted on the port
7705 SAR Interfaces
Page 175