Alcatel-Lucent 7705 Interface Configuration Manual page 104

Card, Adapter Card, and Port Command Reference
For ATM, this command enables or disables ATM cell-level payload scrambling/descrambling using
the x43+1 polynomial as defined in ITU-T I.432.1. Scrambling is enabled by default for the ATM
path/channel. This scrambling is done in addition to SONET/SDH frame scrambling/descrambling,
which is always enabled in the framer.
The no form of this command disables scrambling.
Default scramble
signal-label
Syntax signal-label value
no signal-label
Context config>port>sonet-sdh>path
Description This command sets the C2 byte value. The purpose of this byte is to communicate the payload type
being encapsulated by SONET framing.
Default
0xcf
Parameters value — specifies the C2 byte value, expressed as a decimal integer or a hexadecimal value
trace-string
Syntax trace-string
no trace-string
Context config>port>sonet-sdh>path
Description This command specifies that a J1-path-trace that identifies the circuit be continuously inserted at
source. The specified trace string can be checked against the expected value by the receiver. If no
trace string is entered, a null string is used.
The no form of this command resets the string to its default.
Default
The default J1 value is ALU 7705 SAR. The value does not change when the
string contains all zeros for a non-provisioned path.
Parameters
trace-string — specifies an alphanumeric string value. If the string contains spaces, enclose it in
Page 104
Values
1 to 254 or 0x01 to 0xfe
trace-string]
[
quotation marks.
Values
1 to 62 bytes for SONET or 1 to 15 bytes for SDH
7705 SAR OS Interface Configuration Guide
encap-type
changes. The J1