Alcatel-Lucent 7705 Interface Configuration Manual page 95

Parameters mtu-bytes — sets the maximum allowable size of the MTU, expressed as an integer
report-alarm
Syntax [no] report-alarm [signal-fail] [remote] [local] [no-frame-lock] [high-ber]
Context config>port>ethernet
Description This command specifies when and if to generate alarms and alarm clear notifications for this port.
Parameters signal-fail — reports an Ethernet signal lost alarm
remote — reports remote faults
local — reports local faults
no-frame-lock — reports a "not locked on the ethernet framing sequence" alarm
high-ber — reports a high bit error rate alarm
speed
Syntax speed {10 | 100 | 1000}
Context config>port>ethernet
Description This command configures the port speed of an Ethernet port when autonegotiation is disabled.
Setting the speed turns off autonegotiation.
Default 100
Parameters 10 — sets the link to 10 Mb/s speed
100 — sets the link to 100 Mb/s speed
1000 — sets the link to 1000 Mb/s speed (only supported on GigE SFPs)
7705 SAR OS Interface Configuration Guide
Values 512 to 1572 bytes (see the following table)
Type Mode
10/100 Ethernet Access/Network
10/100 Ethernet Access/Network
GigE SFP Access/Network
GigE SFP Access/Network
Encap Type Default
(Bytes)
null 1514
dot1q 1518
null 1572
dot1q 1572
7705 SAR Interfaces
Max MTU (bytes)
1514 (access)
1572 (network)
1518 (access)
1572 (network)
1572
1572
Page 95