Alcatel-Lucent 7705 Interface Configuration Manual page 123

Parameters all-ones — transmits 11111111
pattern — transmits the user-defined pattern
idle-signal-fill
Syntax idle-signal-fill {all-ones | pattern pattern}
no idle-signal-fill
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description
This command defines the signaling pattern to be transmitted (8-bit value) when the circuit emulation
service is not operational or temporarily experiences underrun conditions. This command is only
valid for CES with CAS.
Note: See the 7705 SAR OS Services Guide for information on CESoPSN services.
Default
all-ones
Parameters all-ones — transmits 11111111
pattern — transmits the user-defined pattern
mode
Syntax mode {access | network}
no mode
Context config>port>tdm>ds1>channel-group
config>port>tdm>e1>channel-group
Description This command configures a TDM channel for access or network mode operation.
An access port or channel is used for customer-facing traffic on which services are configured. A
Service Access Point (SAP) can only be configured on an access port or channel.
When a port is configured for access mode, the appropriate encap-type (atm, cem or ipcp) must be
specified to distinguish the services on the port. Once a TDM channel has been configured for access
mode, multiple services can be configured on the TDM channel.
A network port or channel participates in the service provider transport or infrastructure network
when a network mode is selected. When the network option is configured, only the ppp-auto encap-
type can be configured for the port/channel.
7705 SAR OS Interface Configuration Guide
Values 1 to 255 (can be entered in decimal, binary, or hexadecimal format)
Values 1 to 255 (can be entered in decimal, binary, or hexadecimal format)
7705 SAR Interfaces
Page 123