Alcatel-Lucent 7705 Interface Configuration Manual page 110

Card, Adapter Card, and Port Command Reference
link-delay
Syntax link-delay {activate | deactivate} milliseconds
no link-delay {activate | deactivate}
Context config>port>multilink-bundle>ima
Description This command specifies the time delay between detection of a link activation/deactivation condition
and acting upon it (going in/out of the Rx failure state on a link).
Parameters
activate milliseconds — the time, in milliseconds, used to clear an existing LIF, LODS, or FRI-IMA
deactivate milliseconds — the time, in milliseconds, used to raise an LIF, LODS, or FRI-IMA alarm.
test-pattern-procedure
Syntax test-pattern-procedure
Context config>port>ml-bundle>ima
Description This command enables the context to configure IMA test pattern procedures. Note that this command
and sub-commands are not saved in the router configuration between reboots.
test-link
Syntax test-link port-id
no test-link
Context config>port>ml-bundle>ima>test-pattern-procedure
Description
This command specifies IMA members on which an IMA test pattern procedure is to be performed.
The no form of this command deletes the link from the test-pattern procedure. The test-pattern
procedure must be shut down first.
Default no test-link
Parameters
port-id — the port ID to be used to verify link connectivity within an IMA group
Page 110
alarm. The time specified determines how long is needed for member links to stabilize before
being activated.
Values 1 to 30000 ms
Default 1000
The time specified determines how long before a member link is declared in error and is
deactivated.
Values
1 to 30000 ms
Default
2000
7705 SAR OS Interface Configuration Guide