16
ENGINE
16.3.8
Removing oil filter
16.3.9
Removing thermostat
16.3.10 Setting engine to ignition top dead center
–
Remove screws. Remove the oil filter cover
–
Pull oil filter
Circlip pliers reverse (51012011000) (
300009-10
–
Remove screws. Remove the oil filter cover
–
Pull oil filter
Circlip pliers reverse (51012011000) (
306801-10
–
Remove screws. Take off the thermostat case
–
Pull out the thermostat
300010-10
–
Turn the crankshaft counterclockwise until markings
with the marks of the camshaft support plate.
300023-10
–
Remove screw
Info
Look through the hole to check that the position hole of the balancer shaft
is visible.
–
Screw in special tool
Engine blocking screw (77329010000) (
300024-10
out of the oil filter housing.
2
out of the oil filter housing.
4
.
2
.
2
.
3
with the O-ring.
1
p. 211)
with the O-ring.
3
p. 211)
with the radiator hose.
1
of the camshafts are flush
1
p. 219)
109