6
FORK, TRIPLE CLAMP
–
Push on lock ring
–
Grease and slide on seal ring
Lubricant (T511) (
Info
Sealing ring downward, open side upward.
–
Push on support ring
–
Remove the special tool.
–
Sand the edges of the sliding bushings with 600-grain sandpaper, then clean and
grease them.
Fork oil (SAE 4) (48601166S1) (
200670-10
–
Push on the lower sliding bushing
–
Mount the upper sliding bushing
Info
Without using a tool, carefully pull the stack apart by hand.
200671-10
–
Heat up the outer tube in area
Guideline
50 °C (122 °F)
–
Slide the outer tube onto the inner tube.
–
Hold the lower sliding bushing with the longer side of the special tool.
Assembly tool (T1402S) (
–
Push the sliding bushing all the way into the outer tube.
200672-10
–
Position the support ring.
–
Hold the seal ring with the shorter side of the special tool.
Assembly tool (T1402S) (
–
Push the seal ring and support ring all the way into the outer tube.
200673-10
–
Mount lock ring
Info
The lock ring must engage audibly.
200656-11
.
2
.
3
p. 208)
.
4
p. 207)
.
5
.
6
of the lower sliding bushings.
A
p. 221)
p. 221)
.
7
24