Table of Contents
Advertisement
17
CLUTCH
17.1
Checking/rectifying the fluid level of the hydraulic clutch
Info
The fluid level rises with increasing wear of the clutch lining disc.
Do not use brake fluid.
17.2
Changing the hydraulic clutch fluid
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level under top level of container
»
If the level of the coolant does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
Hydraulic fluid (15) (
100281-10
–
Position the cover with the membrane. Mount and tighten the screws.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Fill bleeding syringe
Bleed syringe (50329050000) (
Hydraulic fluid (15) (
–
On the clutch slave cylinder, remove bleeder screw
syringe
4
–
Inject the liquid into the system until it escapes from hole
without bubbles.
–
To prevent overflow, drain fluid occasionally from the master cylinder reservoir.
–
Remove the bleeding syringe. Mount and tighten the bleeder screw.
–
Correct the fluid level of the hydraulic clutch.
Guideline
Fluid level below top edge of container
–
Position the cover with the membrane. Mount and tighten the screws.
202086-10
.
1
with membrane
.
2
3
p. 207)
.
1
with membrane
.
2
3
with the appropriate hydraulic fluid.
4
p. 211)
p. 207)
.
4 mm (0.16 in)
and mount bleeding
5
of the master cylinder
6
4 mm (0.16 in)
161
Advertisement
Table of Contents
