Engine Assembly; Installing Transmission Shafts - KTM 2013 690 SMC R EU Repair Manual

16 ENGINE
16.5

Engine assembly

16.5.1

Installing transmission shafts

–
Insert the lock ring
seated correctly.
300127-11
–
Clamp the right section of the engine case.
Holder for engine assembly stand (75012001070) (
Support for engine assembly stand (75012001060) (
Engine assembly stand (61229001000) (
–
Make sure that both stop disks
–
Mount the inner bearing race
300087-10
–
Lubricate all bearings.
–
Assemble the two transmission shafts and slide them into the bearing seats
together.
300088-10
–
Mount the upper shift fork
Info
For the assembly of the middle shift fork
third/fourth gear must be lifted.
300089-10
–
Insert shift drum
–
Hang the shift forks into the shift drum.
300090-10
into the groove with suitable pliers and check that it is
3
are installed.
1
on the countershaft.
2
, the middle shift fork
3
into the bearing seat.
6
p. 214)
p. 214)
p. 214)
, and the lower shift fork
4
, the sliding gear of the
4
144
.
5