6
FORK, TRIPLE CLAMP
6.7
Removing fork legs
Preparatory work
–
Raise the motorcycle with the work stand. (
–
Tie the rear of the vehicle down.
Main work
–
Remove screws
–
Press back the brake linings with a light lateral tilting of the brake caliper on the
brake disc. Carefully pull the brake caliper backwards from the brake disc.
Info
Do not pull the handbrake lever when the brake caliper is removed.
S00055-10
–
Loosen screws
–
Unscrew screw
wheel spindle out of the axle clamp. Remove screw
Warning
Danger of accidents Reduced braking effect caused by damaged brake
discs.
–
S00056-10
–
Holding the front wheel, withdraw the wheel spindle. Take the front wheel out of
the fork.
–
Remove screws
holder.
201376-10
–
Remove the screws of the wheel speed sensor
one side.
201377-10
–
Remove screws
201378-10
and spacers
.
1
2
and
.
3
4
about 6 turns and press your hand on the screw to push the
3
Always lay the wheel down in such a way that the brake discs are not
damaged.
and the clamp. Take the brake line and wiring harness out of the
5
. Take off the fork protector.
7
p. 11)
.
3
. Hang the wheel speed sensor to
6
16