18
WATER PUMP, COOLING SYSTEM
18.1
Draining the coolant
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling system components when the engine is hot. Allow the
engine and cooling system to cool down. In case of scalding, rinse immediately with lukewarm water.
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
18.2
Filling/bleeding the cooling system
Warning
Danger of poisoning Coolant is poisonous and a health hazard.
–
Coolant must not come into contact with the skin, eyes, or clothing. If contact occurs with the eyes, rinse with water imme-
diately and contact a physician. Immediately clean contaminated areas on the skin with soap and water. If coolant is swal-
lowed, contact a physician immediately. Change clothing that is contaminated with coolant. Keep coolant out of reach of
children.
–
Stand the motorcycle upright.
–
Place a suitable container under the engine.
–
Remove screw
–
Completely drain the coolant.
–
Mount screw
Guideline
Plug, drain hole of water pump
C00191-10
–
Stand the motorcycle on its side stand on a horizontal surface.
–
Remove radiator cap
C00190-10
–
Refill the coolant.
Alternative 1
Coolant (
Alternative 2
Coolant (mixed ready to use) (
–
Fill the radiator completely with coolant. Mount radiator cap
C00189-10
. Take off the radiator cap.
1
with a new seal ring and tighten it.
1
.
1
p. 206)
p. 206)
M10x1
15 Nm
(11.1 lbf ft)
.
1
162