Removing The Oil Filter - KTM 250 XCF-W USA 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing the oil filter

x
11.115
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
–
Wear suitable protective clothing and protective gloves. If you get scalded, immediately flush the affected areas with luke-
warm water.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Position oil screen
–
Mount and tighten plug
Guideline
Plug for oil screen, long
600695-10
–
Position the oil screen with the O-rings.
–
Mount and tighten plug
Guideline
Plug for oil screen, short
600696-10
–
Place a suitable container under the engine.
–
Remove screws
600687-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing area.
600688-10
with the O-rings.

with the O-ring.

M20x1.5
with the O-ring.

M16x1.5
. Remove oil filter cover
 
out of the oil filter casing.

15 Nm
(11.1 lbf ft)
10 Nm lubricated with
(7.4 lbf ft) engine oil
with O-ring.
81