6
FORK, TRIPLE CLAMP
6.4
Cleaning the dust boots of the fork legs
6.5
Removing the fork protector
6.6
Installing the fork protector
Preparatory work
–
Raise the motorcycle with a lift stand. (
–
Remove the fork protector. (
Main work
–
Push dust boots
Info
The dust boots remove dust and coarse dirt particles from the inside fork
tubes. Over time, dirt can penetrate behind the dust boots. If this dirt is not
removed, the oil seals behind the dust boots can start to leak.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the
L00350-10
brake discs.
–
–
Clean and oil the dust boots and inside fork tube of both fork legs.
Universal oil spray (
–
Push the dust boots back into their normal position.
–
Remove excess oil.
Finishing work
–
Install the fork protector. (
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove the screws on the right fork leg. Remove the fork protector.
S00054-12
–
Position the fork protection on the left fork leg. Mount and tighten screws
Guideline
Remaining screws, chassis
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screws
.
2
–
Position the fork protection on the right fork leg. Mount and tighten the screws.
Guideline
Remaining screws, chassis
S00054-13
p. 15)
on both fork legs downward.
1
Always keep the brake discs free of oil and grease, and clean them with
brake cleaner when necessary.
p. 209)
p. 15)
and take off clamp.
1
on left fork leg. Remove the fork protector.
2
p. 11)
p. 11)
M6
10 Nm (7.4 lbf ft)
M6
10 Nm (7.4 lbf ft)
15
.
1