KTM 2013 690 SMC R EU Repair Manual page 107

16 ENGINE
–
Attach the spark plug connector
–
Plug in the connector of the engine coolant temperature sensor
–
Position the oil pressure sensor and mount and tighten screw
–
Detach connector
S00093-11
–
Reconnect connectors
sor, and the alternator.
S00094-11
–
Push the throttle valve body into the intake flange.
–
Position and tighten hose clip
S00092-11
–
Position the electrical connection on the starter motor.
–
Mount and tighten screw
Guideline
Screw, cable on starter motor
–
Position the ground wire on the starter motor.
–
Mount and tighten screw
Guideline
Screw, starter motor
S00091-11
–
Insert the clutch push rod.
–
Position the clutch slave cylinder.
–
Mount and tighten screws
Guideline
Screw, clutch slave cylin-
der
Screw, clutch slave cylin-
der
S00089-11
–
Mount the engine sprocket with the chain.
–
Position the new lock washer and mount nut
–
Position the rear wheel.
–
Mount the chain adjuster and nut.
–
Push the rear wheel forward so that the chain adjusters are on the tensioning
screws, and tighten the nut
Guideline
Nut, rear wheel spindle
S00090-11
.
8
of the oil pressure sensor.
bl
of the gear position sensor, the crankshaft position sen-
bm
.
bn
.
bo
M5
.
bp
M6
.
bq
M6x20
M6x35
br
.
bs
M25x1.5
.
9
.
bk
3 Nm (2.2 lbf ft)
10 Nm Loctite ® 243™
(7.4 lbf ft)
10 Nm Loctite ® 243™
(7.4 lbf ft)
–
10 Nm
(7.4 lbf ft)
but do not tighten yet.
90 Nm
(66.4 lbf ft)
105