Adjusting The Engine Characteristic - KTM 2013 690 SMC R EU Repair Manual

13 WIRING HARNESS, BATTERY
13.9

Adjusting the engine characteristic

–
Remove the defective fuse.
Guideline
Fuse 1 - 10 A - ignition, combination instrument
Fuse 2 - 10 A - clock, ignition (EFI control unit)
Fuse 3 - 10 A - EPT control unit
Fuse 4 - 10 A - fuel pump
Fuse 5 - 10 A - radiator fan
Fuse 6 - 10 A - horn, brake light, turn signal
Fuse 7 - 15 A - high beam, low beam, parking light, tail light, license plate lamp
Fuse 8 - 10 A - for supplementary equipment (accessories connected with igni-
tion switch)
Fuse 9 - 10 A - for accessories (permanent positive)
Fuse 10 - not used
Fuse SPARE - 10 A/15 A - spare fuses
Info
A defective fuse is indicated by a burned-out fuse wire
600606-10
Warning
Fire hazard The electrical system can be overloaded if the wrong fuses are
used.
–
–
Replace with a spare fuse of the right rating.
Fuse (75011088010) (
Fuse (75011088015) (
Tip
Put a new spare fuse in the fuse box for future use if needed.
–
Check the function of power consumers.
–
Close the fuse box cover.
Finishing work
–
Mount the seat. (
Preparatory work
–
Switch off the ignition by turning the ignition key to position OFF
–
Remove the seat. (
Main work
–
Pull the Map‑Select switch and holder
–
Pull the Map‑Select switch out of the holder.
C00185-12
Use only fuses with the prescribed amperage. Never by-pass or repair
fuses.
p. 177)
p. 177)
p. 60)
p. 59)
.
A
upward off of the retaining bracket.
1
83
.