Removing The Motorcycle From The Work Stand; Starting - KTM 2013 690 SMC R EU Repair Manual

5 MOTORCYCLE
5.8

Removing the motorcycle from the work stand

Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
5.9

Starting

Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventilation, and do not start or run the engine in an enclosed
space without an effective exhaust extraction system.
Caution
Danger of accidents If the vehicle is operated with a discharged battery or without a battery, electronic components and safety
equipment may be damaged.
–
Never operate the vehicle with a discharged battery or without a battery.
Note
Engine failure High engine speeds in cold engines have a negative effect on the service life of the engine.
–
Always warm up the engine at low engine speeds.
–
Position the motorcycle upright, align the special tool and raise the motorcycle.
Work stand (62529055000) (
300201-10
–
Secure the motorcycle against falling over.
–
Remove the work stand and lean the vehicle on the side stand.
300201-10
–
Remove the special tool.
300579-10
p. 214)
12