Figure 81 Removing the Backplane from the Chassis
Replacing the Hard Drive SCSI Backplane
1.
Insert the hard drive backplane into its four chassis standoffs and slide it to the
left. This locks the hard drive backplane in place.
2.
Install the two backplane mounting screws and connect the two SCSI cables.
3.
Replace any removed hard drives.
4.
Connect the backplane power cable and lower the fan power bridge until it snaps
in place.
5.
Replace the PCI cage in the server and secure it.
6.
Replace the top metal cover, and reconnect all of the power and external cables.
7.
Verify the backplane replacement by using the utilities identified in
(page
134). To verify operation, use the iLO MP commands.
Appendix C
82